Fulltext results:
- Stripping the donor
- o the engine block. I sheared off the head of one bolt trying to put the engine block bolts back in. I u... e rubber end. On the passenger side I removed the bolt on top and below the mounting and on the drivers side just the bottom bolt as the manifold stops you getting an impact wrenc... frame disassembly === == Rear Toe Control Pinch Bolt == The first issue I had was shearing the pinch
- Rust Removal and Preparation
- . The solution to this is of course to re-use the bolt however some may not be in the best condition and... ire a good wire wheeling. If you need to reuse a bolt then it is worth considering that by wire wheeling the bolt you will remove any coating or plating it may hav... times find that you'll need to run a die down the bolt if the threads have become distorted when removin
- Stripping the donor
- ap from the top centre of the dash and remove the bolt below it. Remove the 2 air vents above the radio ... 300 }} The picture above shows the rear off side bolt being removed, this is one of 3. If they start ge... d by attaching a lifting chain to the seat runner bolt holes as the balance is about right. Use front ne... p suspension arm, please make sure to install the bolt from the rear to the front, so the nut is on the
- Suspension
- y. Banana shaped 6mm thick plates are provided to bolt to the wishbones in order to return the level of ... p suspension arm, please make sure to install the bolt from the rear to the front, so the nut is on the ... low this means that in any future disassembly the bolt will foul the anti-roll bar mounting on the chassis will require the frame removed or the bolt cut.** ===Bushes=== Many builders take this opp
- Wing Stays
- drilling an 8mm hole in the rear upright for one bolt and the other is attached to the top calliper bolt with a bolt that is 6mm longer than the donor. You can drill with the suspension assembled. Just remove... y to drill. Alternatively remove the top wishbone bolt to allow access by pivoting the hub. {{ wiki:Ima
- Supercharging the Exocet
- l the (red) hole at the back of the body** with a bolt & some PU adhesive. {{:picture5.jpg?400|}} ... t if I needed to adjust I would have enlarged the bolt holes to give a little wiggle room. {{ :IMG_1016... d added / removed washers from the front mounting bolt until I had it at zero (i.e. same angle as the cr
- MK3 Build Section
- rtain ones that need to be longer (brake caliper bolt and wheel bearing bolt to mount wheel spat brackets) - Many other little brackets to mount various th
- Seats & Harnesses
- runners. The Mk2 MX5 runners can be modified to bolt down flat by: - Bending the front mount flat ... will need wrap around type harness’s. These will bolt to the floor plate and tunnel plate hole and wrap
- Bodywork & Mirrors
- and draw the trajectory of the (now mounted) eye bolt. You may want to angle it forward slightly to aid
- Engine
- flat bar; drill a hole in the flat bar so you can bolt it up to the subframe where the fuel tank would m
- Floors & Sides
- along the crossmembers that the seats will later bolt through. You don't want a rivet in the way of you
- Mating the chassis
- sis on to the rolling PPF (power plant frame) and bolt it up. Use washers between the sub frame and chas
- NC Mating the Chassis
- o tighten {{::00004045-photo-2023-07-15-10-20-24_bolt_torque.jpg?400|}} === What additional bolts do I
- Wiring
- th blocks which have the mounting tab on them, to bolt to the mev earth points. They can also be attache
- Pedals & Steering
- tube. *When bolting the steering column in the bolt in the clutch pedal for the column needs replacin