Fulltext results:
- MK3 (NC) Pedals & Steering
- to Align with frame holes === When attempting to fit the steering column the hole in the middle and to... pg}} |} === Brake Pedal Fitting === In order to fit the brake pedal a small corner was cut out off th... ::ncbrakepedal.jpg?300 |}} An alternative is to fit the brake pedal on top you'll see the 2 inner bol
- Supercharging the Exocet
- body – this needs to come off to give you room to fit a custom outlet at an angle. - **Fill the (red)... he SC pulley smaller. It’s actually preferable to fit a larger crank pulley and keep the (larger) stock... £50 (retail is ~£120). The stock pulley is a push fit, but it’s on there tight... really, really tight!
- Bodywork & Mirrors
- of the bonnet clear and are a little trickier to fit but it can be done… {{ :adeb88f1-471c-4008-8499-... e and spend the effort to file it out for a tight fit as the holes for the tiny mounting bolts are real
- Floors & Sides
- The plastic sides are easy to trim to shape and fit using self tapping screws at 150mm centres. It lo... concealed fixings. The panel may need trimming to fit {| style="margin: auto;" |- | {{wiki:Image--016.
- IVA Guide
- plan on fitting fly screens, it’s a good idea to fit them after the test to save having to worry about... tly fixed, if visibility is impaired from it then fit a near side mirror too. {{ :e17c1580-0f1f-4a89-bb
- Body Work and Mirrors
- 047-photo-2023-05-23-11-19-19_internal_panels_not_fit.jpg?400|}} {{:guide:00003619-photo-2023-06-17-14... jor cutting is required to get the side panels to fit, here are examples of a good job {{:guide:000048
- Pedals & Steering
- m to be quite hard plastic and just don't seem to fit. The right hand ones for a Citroen Berlingo 1996-2011 (part no 406643) fit almost perfectly and are sensibly priced. The sma
- Radiator
- need fixing to the frame and it's recommended to fit these as low as possible when using the G-type ch... to trim the Mazda fan cowling down so that it can fit correctly between radiator and chassis; alternati
- Seats & Harnesses
- == ===Seats=== The following seats are known to fit for the Exocet: * MEV supplied GRP * Sparco ... ck runners MEV supplied GRP seats can be made to fit using the runners from the original seat base. Th
- Wheels
- as well or look as good. Nor will the wing stays fit. The current kit comes supplied with wider wings then the original kit, it's possible to now fit up to a 235mm tyre instead of 195mm. {{ wiki:Ima
- Engine
- nel. You can cut and weld the existing midpipe to fit which would be fine for IVA purposes, or if you d
- Fuel Tank
- filled in the centre to allow the plastic neck to fit secure. The original breather hose can be used a
- Handbrake
- make a cover for the cables too. Don’t forget to fit a gaiter around the gear lever too. Much neater w
- Fitting the fuel tank
- l tank under brackets of frame makes it easier to fit boot cover, but some had to trim the front of the
- MK3 Build Section
- at front, tight at back - Petrol tank does not fit race chassis - Frame modification required for