Search
You can find the results of your search below.
Matching pagenames:
Fulltext results:
- Suspension
- fit. The joint should be covered in grease before fitting the cover {{:guide:00000798-photo-2023-01-05-21-22-45_greasing_ball_joints.jpg?400|}} === Fitting Poly Bushes === All of the bushes went is easily... hen found this link [[https://www.powerflex.co.uk/fitting-guides]] which showed it is supposed to twist. I ... the arm and the vice to push it in the last === Fitting Gaz Suspension === Each of the coilovers uses tw
- Body Work and Mirrors
- }} ===Internal Panels=== Issues have been found fitting some of these, the one on top of the tunnel (too ... for IVA {{ ::00004817-video-2023-09-11-17-44-35_fitting_panels.mp4 |}} ===Fitting the bonnet=== Here is a video from a mk1 kit the principles are the same [[htt
- Supercharging the Exocet
- the space between the chassis and the engine, so fitting the bigger M62 while possible (and largely the sa... £20. Remove the small black tube and cap off the fitting on the body of the BPV, run the vac line from the... on a tight budget), I went for the weld-your-own fitting kit from Garage42 (£190 delivered). {{ :picture1
- MK3 Build Section
- nnel panel too small - Top of tunnel panel poor fitting, loose at front, tight at back - Petrol tank do... rnesses|List of seats that can be used along with fitting instructions|:ncseats_harnesses|{{:011-seat_belt.
- Suspension
- ====== Suspension ====== When fitting the front shock absorbers it is necessary to cut out the centre brid... o solve the problem shown below. Please note when fitting new bushes there are *many* sizes of anti roll ba
- Wing Stays
- hem to the underside with PU adhesive. If you are fitting the LED lights into your kick wings or G-type wings fit them before fitting wings to car. It is important that thread lock p
- Bodywork & Mirrors
- t pins to flush catches and Dzuz type fasteners. Fitting fasteners to the top of the bonnet with the locat
- Brake / Clutch / Fuel Lines
- cut way the original hose and it leaves a barbed fitting to connect to the tank or fuel rail. The fuel pi
- Handbrake
- plastic handbrake cover from the donor will need fitting and you may be tempted to make a cover for the ca
- IVA Guide
- ng back lights to instruments. * If you plan on fitting fly screens, it’s a good idea to fit them after t
- MK1 / MK2 / MK2.5 Build Section
- rnesses|List of seats that can be used along with fitting instructions|:seats_harnesses|{{:011-seat_belt.sv
- Fitting the fuel tank
- ====== Fitting the fuel tank ====== The fuel take is bolted onto these brackets, putting the front of the
- NC Mating the Chassis
- frame M10 x 1.25mm thread lenght 40mm, get ones with 14mm flanged head to enable fitting socket to tighten
- MK3 (NC) Pedals & Steering
- 2739.jpg}} | {{img_2741.jpg}} |} === Brake Pedal Fitting === In order to fit the brake pedal a small corn
