Fulltext results:
- Rust Removal and Preparation
- may need to replace bushes, mounts etc so it is a good idea to press the old ones out before restoring t... eaning. Once the thicker dirt is removed it is a good idea to use a degreaser to get it sparkling. The ... this is the best way to make your old parts look good again and most importantly, you will get a longer... me may not be in the best condition and require a good wire wheeling. If you need to reuse a bolt then
- Engine
- gine, this is completely optional, however it's a good time to change the clutch if needed or for preven... aiming for a power build then it's also a really good time to change the flywheel if you are wanting a ... V sell a stainless steel rear silencer that looks good and is tuned to comply with noise requirements.
- IVA Guide
- s. * If you plan on fitting fly screens, it’s a good idea to fit them after the test to save having to... en you drive to & from the test center. It is a good idea to drive to the test if you are confident th... testing, anyone with anything tearing around, not good. ===IVA Application form filling assistance===
- Bodywork & Mirrors
- secure wing mirrors to the top chassis rail is a good idea. Check position a few times before getting o... es of at least 2.5mm radius. Long stem mirrors, a good choice. {{ :74a08c82-e193-414e-b1ff-d4b2c53ff650
- Body Work and Mirrors
- et the side panels to fit, here are examples of a good job {{:guide:00004898-photo-2023-09-18-13-12-32_... 2-34_side_panels_2.jpg?400|}} I didn't do such a good job but I am going to trim them more for IVA {{
- Stripping the donor
- You will also need axle stands, a decent jack and good quality spanners/tools that are up to the job. If... ough the floor. Then jack up the car and place on good solid axle stands for access to the underside. Ne
- Supercharging the Exocet
- lly so you can satisfy yourself you are getting a good’un before you hand over the cash. You can always ... lock). __**Supercharger oil - £13**__ It’s a good idea to change the oil in the supercharger as it’
- Brake / Clutch / Fuel Lines
- ethanol is more and more common in fuel so it's a good idea to make sure it's compatible. You have an op
- Build Overview
- spares market so running costs are kept in check. Good news when you strip your donor too as you will be
- Fuel Tank
- t and dropped as described. All tanks also need a good earth to the frame as this will be tested at the
- Handbrake
- loor offcut. {{ wiki:Image--043.jpg?300 }} ==A good explanation video on the MX5 system is available
- How to edit or create pages in the wiki
- hat has been used previously, this will provide a good starting point, remember anything you change and
- Lighting & Instruments
- ou attached to the loom, and make sure you have a good earth on all the points above. Obviously, you do
- Fitting the fuel tank
- ng the front of the taken under the frame seems a good option {{:guide:wheretoboltfueltank.jpeg?400|}}
- Stripping the donor
- You will also need axle stands, a decent jack and good quality spanners/tools that are up to the job. If