Fulltext results:
- IVA Guide
- ====== IVA Guide ====== Here is an [[https://www.gov.uk/government/publications/individual-vehicle-approval-iva-for-cars-help-to-get-a-pass/individual-vehicle-approval-iva-for-cars-help-to-get-a-pass|Helpful hints on how to pass the IVA]] You are required to ensure that there are no e
- Lighting & Instruments
- ting them off as you may find you have created an IVA fail point should, for instance, the backlighting... e front indicator on the side as shown below. For IVA the headlight will need rotating in the rim to gi... need mounting separately paying attention to the IVA requirements, the fog light needs to be on the of... uster. The fog light switching has an interesting IVA requirement: it must only operate when the main l
- Turning off airbag light
- urnoffairbaglight.mp4 |}} ====== Headlights and IVA ====== Some people have passed IVA with the headlights, others have not. Rotating the lens may help, but it appears the discretion of the IVA tester is a factor as to whether these pass or no... ions sell the same lights but advise they are not IVA compliant and were originally designed for a moto
- Brake / Clutch / Fuel Lines
- emove it. You do not need to keep ABS to pass the IVA test even if the donor was fitted with it. If yo... ines.jpg?300 }} ===Brake fluid level test=== The IVA inspector will ensure that in the event of low fl... the necessary certifications in order to pass the IVA, ethanol is more and more common in fuel so it's
- Engine
- .jpg?300 }} ===Exhaust=== For the purpose of the IVA test it is easier to use the donor exhaust althou... e existing midpipe to fit which would be fine for IVA purposes, or if you do not have access to a welde... ith "flexible exhaust pipe" using clamps. This is IVA friendly. On most "skates" you will find that th
- Fuel Tank
- filler cap from the MX5 can be used. (Be aware of IVA regulations that if the fuel cap is not lockable ... earth to the frame as this will be tested at the IVA inspection, this can be done either through metal... e requirement for a fuel drip tray, it seems some IVA inspectors expect this and others do not. The co
- MK3 Build Section
- need a lot of cutting - The Headlights can pass IVA but there are also know to fail IVA, Car Builder Solutions that sell the same headlights advise they are not IVA compliant <div class="exocet-menu"> ^ ^ ^ | {
- MEV Exocet Build Guide
- unted. | | {{:010-mechanic.svg?nolink&48x48}} | [[iva_guide|**IVA Guide**]] | A handy list of items to check and details for pre and post IVA. | | {{:020-information.svg?nolink&48x48}} | [[su
- Wiring
- nd the seats and a box made to protect it. Not an IVA requirement. {{ wiki:Image--039.jpg?300 }} ===W... e accidently leaving the fog lamps on. This is an IVA requirement since 2013 If you are using an early... www.carbuilder.com/uk/rear-fog-controller-for-new-iva-rules |here]] === Stripping the wiring loom ===
- Bodywork & Mirrors
- ice drill once! Wing mirrors must comply with the IVA regulations in terms of size and position in orde... e the correct field of view. You should check the IVA manual for this information to ensure your chosen
- Floors & Sides
- hese, whether hard line or flexi lines, and to be IVA compliant 30cm is the usual distance between moun
- Handbrake
- covers sharp edges that may cause concern for the IVA inspector. It is always better to see knock on tr
- Body Work and Mirrors
- h a good job but I am going to trim them more for IVA {{ ::00004817-video-2023-09-11-17-44-35_fitting_
- Wiring
- race/find which the wire fed the dash back-light (iva and mot fail). Once running with all lights etc t
- Seats & Harnesses
- e hole and wrap around the harness bar. Note that IVA inspectors will want access to the adjusters on t