Exocet Build Guide


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
lighting_instruments [2025/01/21 17:36] robskilighting_instruments [2025/01/21 17:40] (current) robski
Line 62: Line 62:
 {{ wiki:Image--037.jpg?300 }} {{ wiki:Image--037.jpg?300 }}
  
-Note the fog and hazard switches neatly mounted in the corners of the pod. The switches must illuminate when switched on unless there are tell-tale lamps for fog/hazard in the instrument cluster. Sometimes the backlighting of these buttons can be rather bright compared to the instrument illumination, even when wiring them through the dimmer control: consider wiring the two lights in series rather than parallel to reduce the brightness+Note the fog and hazard switches neatly mounted in the corners of the pod. The switches must illuminate when switched on unless there are tell-tale lamps for fog/hazard in the instrument cluster. 
-The fog light switching has an interesting IVA requirement: it must only operate when the main lights are on, and when the main lights are turned off it must turn off too and NOT turn back on again when the main lights are next turned on. MX5s do 'interesting' things with switches and wiring depending on model and equipment to make this happen. The required functionality can be achieved using a 'flip-flop' latching relay board as available on a well known auction site, and a momentary push-button switch marked as a rear fog light. There should be no requirement for the switch to indicate the fog light is on as there is a warning light in the instrument panel.+The fog light switching has an interesting IVA requirement: it must only operate when the main lights are on, and when the main lights are turned off it must turn off too and NOT turn back on again when the main lights are next turned on.  MX5s do 'interesting' things with switches and wiring depending on model and equipment to make this happen.  The required functionality can be achieved using a 'flip-flop' latching relay board as available on a well known auction site, and a momentary push-button switch marked as a rear fog light.
  
 ===Hyper flashing when using LED lights - Mazda MX5 Mk2.5 (Thanks to Jim Titmuss)=== ===Hyper flashing when using LED lights - Mazda MX5 Mk2.5 (Thanks to Jim Titmuss)===
Driven by DokuWiki
lighting_instruments.txt · Last modified: by robski