Fulltext results:
- Stripping the donor
- eed roll without the engine and diff sinking. {| style="margin: auto;" |- | {{ :mx5ncfrontstrut.png?300 ... 3-photo-2022-09-13-10-51-21_skate.jpg?400|}} {| style="margin: auto;" |- | {{oldparts.jpg?300}} | {{fin... elocated into the mid section of the exhaust. {| style="margin: auto;" |- | {{:ncremovelamda.jpg?direct&
- Brake / Clutch / Fuel Lines
- between the two master cylinders and systems. {| style="margin: auto;" |- | {{:0e0c95a3-b3c6-4d53-bdff-f... to both front wheels as shown in Fig5 below. {| style="margin: auto;" |- | {{ :brake-proportioning-valv
- Floors & Sides
- points although just needs to be "secure".// {| style="margin: auto;" |- | {{PUframe.jpg?300}} | {{floo... d fixings. The panel may need trimming to fit {| style="margin: auto;" |- | {{wiki:Image--016.jpg?300}}
- Fuel Tank
- e tank from under the brackets for clearance. {| style="margin: auto;" |- | {{wiki:Image--040.jpg?400}} ... nd wrapped in nylon hydraulic line protector. {| style="margin: auto;" |- | {{:12c31bca-1ca3-46ac-a9fd-4
- Lighting & Instruments
- ilt in, find them online. ===Light units=== {| style="margin: auto;" |- | {{wiki:Image--033.jpg?300}} ... then flash at the correct rate for IVA test. {| style="margin: auto;" |- | {{mk2.5resistor.png?300}} |
- Stripping the donor
- the suspension parts, brakes and sub-frames. {| style="margin: auto;" |- | {{oldparts.jpg?300}} | {{fin... can be found in the [[wiring|wiring]] section {| style="margin: auto;" |- | {{wiki:Image--006.jpg?300}}
- Suspension
- here is an example of it completely removed. {| style="margin: auto;" |- | {{wiki:Suspensioncutaway.jpg... a small guide from a suspension manufacturer. {| style="margin: auto;" |- | {{mk1topmount.jpg?300}} | {{
- Build Overview
- press yourself, making the choice of colour, nose style and wheels is just the start. Just pick a budget
- Engine
- the subframe where the fuel tank would mount. {| style="margin: auto;" |- | {{wiki:Image--050.jpg?300}}
- Mating the chassis
- he sub frame and chassis on the rear 4 bolts. {| style="margin: auto;" |- | {{wiki:Image--018.jpg?300}}
- MK3 (NC) Pedals & Steering
- t before knocking it off the steering column. {| style="margin: auto;" |- | {{:img_2738.jpg}} | {{img_27
- Suspension
- pplying smaller spacer to address this issue. {| style="margin: auto;" |- | {{:nclugwidth.jpg?direct&300
- Pedals & Steering
- g ====== The steering column is shown below. {| style="margin: auto;" |- | {{wiki:Image--023.jpg?300}}
- Radiator
- purchased with the kit for the MK1 radiator. {| style="margin: auto;" |- | {{wiki:Image--045.jpg?300}}
- Seats & Harnesses
- pull without distortion or load on shoulders. {| style="margin: auto;" |- | {{:0a2ec3d9-142c-4ecb-9afc-1