When attempting to fit the steering column the hole in the middle and top of the column did not align with the frame holes. I cut about 8mm off the bottom of the steering column where the splines go into the swivel joint and then everything just about lined up when bolted together. Heat applied to the swivel joint before knocking it off the steering column.

{| style=“margin: auto;”

In order to fit the brake pedal a small corner was cut out off the bracket as the lug for mounting the steering column stopped it from going far enough towards the middle of the car

An alternative is to fit the brake pedal on top you'll see the 2 inner bolts are only in half holes in the bracket, so I made some half washers etc. Outer bolts through everything