Fulltext results:
- Rust Removal and Preparation
- lot of time but a smaller budget then this is the way to go. You will need some tools, namely a drill a... achments for an angle grinder will be the fastest way of removing old rusty metal, leaving mostly clean... than a wire wheel and on smaller parts, can eat away more material. Now that you have clean metal yo... === If your budget allows then this is the best way to make your old parts look good again and most i
- Supercharging the Exocet
- any horrific noises. If there is any doubt, walk away as rebuilds can get expensive. You don’t need th... se (blow off) or redirect (bypass) this pressure away from the closed inlet throttle body – the most common way of doing this is to re-circulate the compressed a... ck limit DB tests) and I don’t want to risk a runaway throttle! I bought a TB from a mk1 1.6 MX5 for £
- Brake / Clutch / Fuel Lines
- ar brake line to the port with an arrow pointing away from the valve body and the front brake line to t... the driver's side (UK) frame, this is to keep it away from the exhaust and prop shaft. You can alternat... l pipe connections from the donor, you simply cut way the original hose and it leaves a barbed fitting ... swapped and secondly if you do get them the wrong way around and then remove them you may get splashed
- Lighting & Instruments
- s arrows on the lens, ensure they point the right way. Front indicators need to be seen from 20 degree... o it is worth considering using a single pole one way switch with a hazard symbol on it. It does not ne... symbol to ground the orange wire is still a neat way to go. Number Plate Lights The number plate ligh
- Wiring
- the tab first. I als0 used many of the mx5 multi way earth blocks which have the mounting tab on them,... hrink over the sleeve joints. Abit of a faff, but way cheaper than the £60 extender that is the alterna... alarm module but I believe that can be removed anyway. Take your time and work through it. Start with r
- Build Overview
- great value donors, buy an MOT failure and throw away the rusty bits. -Tons of tune up options availa... e you through the process and hope that along the way you will spot areas where you can add your own id
- Pedals & Steering
- *The pipe from servo to inlet manifold has a one way valve. The arrow should point to the head. *The... rack by hitting the bracket. It can adjust either way. This helps locate the column to the rack pinion.
- Stripping the donor
- m with the body in place holding them down is the way to go in the absence of spring compress tools. I... hands, 10 fingers and 2 eyes, let’s keep it that way!** If you do not have a hoist available then it'
- Welcome to your new DokuWiki @wiki
- t that thrives through user contributions. A good way to stay informed on what's going on and to get us... okuwiki.org|DokuWiki User Forum]] is an excellent way to get in contact with other DokuWiki users and i
- Engine
- ger at each left and right sides. The most common way to do this is to cut an exhaust hanger off your o
- Floors & Sides
- later bolt through. You don't want a rivet in the way of your seat bolts! You may wish to use a sealan
- Fuel Tank
- be bolted to the frame. Make sure that it leans away from the exhaust so that any fuel that does end u
- IVA Guide
- on your test fee. On the other hand it is a great way to bed in new brake pads, and ensure it is hot in
- Lighting & Instruments
- circled) so it is no longer attached. The easiest way is with some small cutters and snip the pin at th
- MK3 Build Section
- cation required for ITBs - Side body panels are way too big and need a lot of cutting - The Headlig