Search

You can find the results of your search below.

Matching pagenames:

Fulltext results:

Rust Removal and Preparation
8 Hits, Last modified:
ld ones out before restoring the parts. === Wire Wheel & Paint === If you have a lot of time but a smal... cheap, these usually come with a large brass wire wheel that will make quick work of most parts cleaning.... and likely very rusty. While you can use a brass wheel on a drill, this will take a long time and won't ... more aggressive will speed things up. Steel wire wheel attachments for an angle grinder will be the fast
MK3 Build Section
6 Hits, Last modified:
s that need to be longer (brake caliper bolt and wheel bearing bolt to mount wheel spat brackets) - Many other little brackets to mount various things - Al... (potentially rectified) - Front Wing Stay need wheel spacer - Rear Wing Stage not high enough and need wheel spacer (potentially rectified) - Driver side fo
IVA Guide
3 Hits, Last modified:
nuts. There is an exempt zone around the steering wheel but even the bottom outside edge of the side pane... Replicar/Exocet |- |Type of body: |Sports car |- |Wheel Plan: |2 axle rigid |- |Colour: |State body colou... ble mass: |NA |- |Track width: |1450 depending on wheel/spacer choice |- |Width: |NA |- |NOx: |NA |- |Rev
MK1 / MK2 / MK2.5 Build Section
2 Hits, Last modified:
f the chassis over the skate. | | {{:045-steering_wheel.svg?nolink&48x48}} | [[pedals_steering|**Pedals &... back to the start of the guide. | | {{:075-alloy_wheel.svg?nolink&48x48}} | [[wheels|**Wheels**]] | ET e
Wing Stays
2 Hits, Last modified:
the tyre The front and rear ones rub against the wheel (MEV suggest using hub centric spaces 25mm bit ru... ng the wing stays to stop the rubbing against the wheel is likely to crack any powder coating if already
Build Overview
1 Hits, Last modified:
ue British sports car layout of front engine rear wheel drive and offering excellent value for money. One
Handbrake
1 Hits, Last modified:
nd in the adjusters in the rear pistons until the wheel locks, then do a 1/4 turn back to allow slight mo
NC Mating the Chassis
1 Hits, Last modified:
e Chassis ===== ===Getting the kit home=== A long wheel base van is recommended {{:guide:00001017-photo-
Stripping the donor
1 Hits, Last modified:
push out the insert. Then used a chisel and wire wheel to remove the rubber. Finally there is a steel sl
Suspension
1 Hits, Last modified:
ct&300}} |} ===Setting up the Gaz suspension and Wheel Alignment=== The wheels will need aligning, this
Pedals & Steering
1 Hits, Last modified:
column, this can be altered if you would like the wheel higher. ==== Steering Rack length adjustment ===
Supercharging the Exocet
1 Hits, Last modified:
which then turns a shaft attached to a compressor wheel that compresses the air fed to the engine. There
Suppliers
1 Hits, Last modified:
rsport - Track day tuition, Race Car Preparation, Wheel alignment, Full Garage Service]] *[[https://the
Wing Stays
1 Hits, Last modified:
. You will need a spirit level to ensure that the wheel rim does not protrude beyond a vertical line from